1. Clean the door and the door frame thoroughly. It is essential that surfaces are clean and free of silicone or polish.
2. The channel, flexible cover and gap cover all have self adhesive strip on faces which attach to the door and door frame.
3. Before fitting you must remove pink cover from adhesive strip.
4. When securing ensure adhesive is firmly pressed into place.
INSTALLATION INSTRUCTIONS
To fit the Kindagard® Door Hinge Safety System just follow the simple instructions below. For high pedestrian traffic areas, securing the product using panel pins or self tapping screws could be an advantage. Offer the Kindagard flexible gap cover to the door to check the length. If you need to shorten the Kindagard system heavy duty scissors are recommended.
Gap Cover - 2 Part
Clean the door and door frame thoroughly.
With door shut, secure channel into the corner of the door.
Secure flexible cover to door frame using edge of channel as a guide for positioning.
Open door. Line up foot on flexible cover to channel.
Locate and snap foot into channel on door.
Close door.
Hinge Cover - 1 Part
Secure the ‘L’ shaped end to door butting up to the back of the hinge.
Roll cover over the hinge and secure the ‘T’ foot to the door frame.
